11-01-2009, 07:57 AM
I started the modification of the cockpit seating. Â My first step was to extend the lazarette sides all the way to the hull sides. Â I made cardboard templates of the oddly shaped trapazoids need to fill the gaps, then transferred the templates to plywood and cut them out. Â I used stringers on top and botton following the curve of the lazarette. Â The trapazoids were glued and screwed to the stringers and to 1X2 panel jointers which attached them to the lazarette. Â Next I laid out and installed the strigers for the seat section in the forward section of the cockpit. Â Next up is the support at the lazarette for the wooden seats that will span the open space between the forwad seat and the lazarette. Â I'm following Barry Payeatt's idea. Â
I'll post some photos of my progress.
Dave
I'll post some photos of my progress.
Dave