Recent Forum Posts
Here are the 10 most recent Forum Posts:
Learning My Lesson About Going CheapSand the surface of your mesh mess with 120 grit. Don't worry about sanding through the mesh on that tape. If you haven't put ...
by Terry Peterson in Builders Bulletin Board
Fleet Locations
Our Weekender "Joedee's Song" won't get wet this season unless The Boat Shed leaks and we're looking forward to completion by n...
by Alan Mallett in Builders Bulletin Board
Question on hull finishing
Good Looking vessel, Sean! Good Luck to you at launch! capnpablo
by Paul_Newman in Builders Bulletin Board
Sanding Wood Flour Thickened Epoxy?
Dave a cut water is a front piece added to the the keel/stem going up to the shear (top edge of the rub rails). This is normall...
by Craig_Gleason in Builders Bulletin Board
Paint question
Thanks, Paul. Great answer. Dave
by Dave Blake in Builders Bulletin Board
Sailing season: Slow Start Says Sailor
Yeah, the guy in the water was fishing around for our fuel tank cap. I was just about to go in there myself, I didn't even notic...
by Keith Shergold in True North Fleet
Cutting compound angles - HELP!!
Thanks guys. I'm really having a brain block on this thing. I think Terry's idea is what I will have to do; I'm just going to ha...
by David Oelker in Builders Bulletin Board
Interlux solvents
Terry; Thanks for the information, not just you but everyone here. I'm 26 hours into the build of "JoeDee's Song", keel in the...
by Alan Mallett in Builders Bulletin Board
problems with papers in palma de mallorca p.c.
In Montana nonmotorized boats are not required to be registered or have hull numbers. Boats under 12 feet can have small electr...
by Terry Peterson in Builders Bulletin Board
Chine runners on Weekender
In defense of lawn mowers engines they suffer from the same thing all engine builders do, the need for flexibility with limited ...
by Paul Riccelli PE,NA in Builders Bulletin Board
Visit our Forums today!
Member Sites
Sponsors